Silvercrest 113854, Operation And Safety Notes

Page: 8 / 37

8 GB
Setting up
pushing away the battery compart-
ment cover
4
downwards. Insert
two batteries AAA. Make sure you
fit the battery the right way round
(polarity).
2. Press one of the ON / OFF buttons
2
or
3
to test whether the remote
control works; if it does, the power
indicator light will come on
1
.
Q
Setting up the remote-
controlled socket
1. Plug the remote-controlled socket
into an earthed household socket.
2. The LED operating status display
5
will now flash slowly for approx.
30 seconds after plugging in.
3. Aim the remote control at the
remote-controlled socket at a
distance of approx. 50 cm.
4. With the LED operating status dis-
play
5
flashing, press the desired
ON button of the channel ON /
OFF button
2
(A, B, C or D) on
the remote control. The LED operat-
ing status display
5
will now light
continuously. You can now use the
remote control to switch a connect-
ed device on or off using.
5. Repeat this process with the other
remote-controlled socket.
6. You can use one channel ON/OFF
button
2
to switch several remote-
controlled sockets at once. You can
further train six remote controls suc-
cessively and use these for a single
receiver. This means you can switch
one appliance on and off from up
to six different places.
7. In this case, synchronise every
remote-controlled socket with the
channel of the remote control.
8. The codes for the remote control
will also remain stored when
changing the batteries.
9. The codes will remain permanently
stored when disconnecting the
remote-controlled socket from the
power supply.
10. Avoid interference: Ensure the vari-
ous remote-controlled sockets are
approx. 50 cm apart.
11. The LED operating status display
5
indicates if the remote-controlled
socket is in ON/OFF mode.
Deleting a code:
To delete a code, first repeat steps
1 – 3.
With the LED operating display
5
flashing, press the desired OFF
button of the channel ON/ OFF
button
2
(A, B, C or D) you wish
to delete on the remote control.
The LED operating status display
5
will flash rapidly for approx. 2 sec-
onds to confirm deletion.
It will then flash slowly again for
approx. 30 seconds and a new
code entered.
Deleting all codes:
To delete all codes, first repeats
steps 1 – 3.
Then with the LED operating status
display
5
flashing, press the
ALL-OFF button
3
on the remote
control. The LED operating status