6
SHMSB 300 A2
GB
2) Push the whisks
8
or the kneading hooks
9
into the slots
7
until they click audibly into
place and are secure.
Always insert the kneading
hook
9
or the whisk
8
without the ring into the
intended slot on the appli-
ance (labelled with an icon).
Always insert the kneading
hook
9
or the whisk
8
with
the ring on the shaft into the
intended slot on the appli-
ance (labelled with an icon).
3) Insert the mains plug
4
into a mains power
socket.
4) To start operating the appliance, move the speed
switch
2
to the desired speed setting. You
can select between 5 speed settings and also
use the Turbo button
3
(see section “Speed
levels”).
5) Press the tool release button
1
to release the
whisks
8
or the kneading hooks
9
.
NOTE
►
For safety reasons, the whisks
8
and kneading
hooks
9
can only be released if the speed
switch
2
is set to position "0".
Pureeing
WARNING! RISK OF INJURY!
►
Never use containers made from glass or
other easily breakable materials. These con-
tainers may be damaged and cause injuries.
ATTENTION! DAMAGE TO PROPERTY!
►
Never use the blender
0
for hard foodstuff s
such as: coff ee beans, ice cubes, sugar,
cereals, chocolate, raw/hard vegetables etc.
This could result in serious damage to the
appliance.
1) Open the fi xture with the safety cover
5
and
hold the safety cover fi rmly.
NOTE
►
The blender
0
can only be used if the
whisks
8
or the kneading hooks
9
are not
installed.
2) Push the blender
0
into the fi xture
5
, push
it down and tighten it by turning fi rmly several
times in the direction of the arrow .
3) To avoid overfl owing, the container used for
blending should only be fi lled to about 2/3 of
its capacity. Select a suitably large container
or use the supplied measuring jug
q
.
NOTE
►
In order to ensure that the ingredients are
properly mixed, the food that is being pro-
cessed should cover at least the lower part
of the blender
0
.
►
Do not switch the hand mixer on until the
blender
0
has been inserted into the ingre-
dients to be blended.
4) Move the speed switch
2
to the “Blender”
setting (see chapter “Speed levels”) and
press the Turbo button
3
. Keep the Turbo
button
3
pressed down during the whole
procedure. The appliance stops as soon as it
is released.
ATTENTION! DAMAGE TO PROPERTY!
►
Do not operate the blender
0
continuously
for longer than 1 minute. After one minute of
use, allow the appliance to cool down fully.
IB_109576_SHMSB300A2_HR_RO_GR.indb 6
17.12.14 09:27
Summary of Contents for 109576
Page 3: ...B A ...
