- 28 -
Taking the steam iron out of
service
• Remove the plug from the wall power socket.
• Empty the water tank and clean the ironing sole
e
.
• Place the cooled down steam iron on the station
q
and secure it, in that you slide the unlocking
switch
0
into the position
.
• The power cable
9
can be wrapped and stored
around the cable retainer
w
on the underside of
the station
q
:
Anti-drip function
With conventional steam irons, water can drip from
the iron soleplate
e
at low temperatures. This iron,
however, has an anti-drip function. At low tempera-
tures the iron automatically switches off the steam-
blast function. When this happens, a "click" can be
heard. You must then set a suitable temperature with
the temperature regulator
7
. As soon as this is
reached, steam production is continued.
Cleaning
Self-cleaning function
• Connect the steam iron with the cable base
8
.
• Fill the water tank to the marking MAX.
• Insert the plug into a wall socket.
• Place the temperature regulator
7
into the
position MAX.
• Adjust the steam regulator
3
to maximum steam
power.
• Allow the steam iron to heat up until the heat
control lamp
6
extinguishes and once again
glows.
• Hold the steam iron horizontally over a catch-
ment receptacle.
• Position the steam regulator
3
at the maximal
steam power level. Press and hold down the
button Self-clean
r
. Thereby, steam and boiling
water flows from the steam exit holes in the iro-
ning sole
e
. Impurities that may be present are
washed out.
• Release the Self-clean button
r
as soon as all
of the water has exited.
• Thoroughly dry the ironing sole
e
. For this, slide
the ironing sole
e
back and forth over a hand
towel or an old piece of material several times.
• Allow the steam iron to cool down before pla-
cing it in storage.
Housing
Potentially fatal danger!
Disconnect the plug before cleaning. Otherwise
there is the risk of you receiving a potentially fatal
electric shock!
Risk of physical injury!
Allow the appliance to cool before cleaning it.
If you do not, there is a risk of you receiving burn
injuries!
• Clean the housing with a soft, dry cloth only.
Important!
Do not use aggressive, abrasive or chemical cleaning
agents. These could attack the surfaces and cause
irreparable damage to the appliance.
Metal parts
• Clean the metal components with a lightly water-
moistened cloth and a mild, non-abrasive cleaning
agent.
IB_102540_SDBK2200C3_LB2 31.07.2014 14:59 Uhr Seite 28
DIN A5 148 mm x 210 mm
