51
GB
Wet shaving (only for battery
operation)
DANGER! Risk of electric
shock!
• The hand-held device and the plug-in
power unit
13
are not waterproof.
Wet shaving is only allowed when us-
ing battery power.
WARNING! Risk of material damage!
For wet shaving use shaving foam or lather
only; never use shaving gel or shaving
cream. This could adhere to the cutter
blocks
12
.
• Before shaving, smooth a thin layer of
shaving foam on your face.
• Shave your face as described in the
chapter "Dry shaving (Rechargeable
battery and mains operation)".
• If shaving foam should clog the shav-
ing head
3
, clean the shaving head
under running water (chapter "Clean-
ing and maintenance of the device" on
page 51).
Cutting long hair
Use the long hair trimmer
11
on the back of
the shaver to shorten your beard and side-
burns.
1. Take off the protective lid
10
.
2. Push the long hair trimmer
11
up.
3. Switch on the shaver with the on/off
6
switch.
4. After use, switch the device off, slide
the long hair trimmer
11
back to its
original position and clean the device
(chapter "Cleaning and maintenance
of the device" on page 51).
Designer stubble
NOTE:
depending on beard growth and
shaving, the appearance of a designer
stubble can vary greatly.
To maintain a designer stubble look, shave
dry with an attached protective lid
10
reg-
ularly. In this case, the protective lid acts as
a designer stubble attachment.
• Shave your face as described in the
chapter "Dry shaving (Rechargeable
battery and mains operation)".
7. Cleaning and
maintenance of the
device
DANGER! Risk of electric
shock!
• The shaving head
3
can be cleaned
under running water. Disconnect the
device from the plug-in power unit ca-
ble
13
prior to doing so.
• The plug-in power unit and the corre-
sponding cable
13
must not be held
under running water and must not be
immersed in other liquids.
WARNING! Risk of material damage!
• Do not use any astringent or abrasive
cleaning agents.
• Do not place excessive pressure on the
shaving foils
1
. They are thin and can
be damaged easily.
• Use the cleaning brush
14
for clean-
ing the cutter block
12
only. Under no
circumstances should the shaving
foils
1
be cleaned with it.
__KRA100057_B2.book Seite 51 Montag, 26. Mai 2014 3:27 15
