5.Installion
Lamp assembly:
5.1
Fitting the lamp
To insert the lamp MSD 250 or MSD 250/2 open the top cover of the projector-head (see
the drawing to identify which cover is top) by loosening the 3 screws on the cover. Then
open the small lamp cover by loosening 2 fastening screws (see the drawing). If changing
the lamp, remove the old lamp from the socket. Insert the lamp to the socket. Do not
install a lamp with a higher wattage! A lamp like this generates temperatures the device is
not designed for. Damages caused by non-observance are not subject to warranty. Please
follow the lamp manufacturer
s notes! Do not touch the glass bulb with bare hands
during the installation! Make sure that the lamp is installed tightly into the lampholder
system. Adjust the optimal distance 1-1.5 mm from the lens by turning the screw "A" (see
the drawings "Lamp adjustment" below) on the rear panel of the head. Then close the
small lamp cover by tighten 2 fastening screws again. Reclose the top cover of the head
and tighten the 3 screws.
‘
Fastening screws
Fastening screws
Lamp cover
Top cover
Lamp
