Bomi Furniture P/L trading as Silver Lynx ABN 99 006 489 541 11-17 Sages Road Glenroy Victoria 3046 Australia
T:+61 3 9359 4000 F:+61 3 9359 4322 E:[email protected] W:www.silverlynx.com.au
STEP 8
–
From the inside of the
Drawer Box, use the 2x 30mm bolts
and 2x washers to secure the Drawer
Box to the Side Rail (1 each side)
STEP 9
–
Ensure the bed is square
and then tighten all bolts using the allen
key provided. Once snug, tighten only
with ¼ turn of the Allen Key. DO NOT
USE cordless drivers or power drills as
over-tightening can cause damage to
some components.
STEP 10
–
Re-install the drawers by
lining up the runner components on
each drawer with the components in
the Drawer Box. Ensure your drawers
have not swapped position or they will
not fit. NOTE: you do not need to press
the plastic clips, but must make sure
the drawer goes in straight and evenly.
If the drawer does not go all the way to
the closed position, pull it open a few
centimetres and then push closed
again.
Having trouble? See
*Helpful
Tips*
at the end of this document
STEP 11
–
To set up the slat and
spine system, proceed to the
instructions titles “Amendment to
instructions for all SilverL
ynx beds”.
Note the 2x 38mm screws provided in
the hardware pack can be used in this
section of the assembly
STEP 10
STEP 9
STEP 8
