SETTING UP YOUR SPOTPAK:
•
The hose is supplied fitted at one end to the spray lance.
•
Fit the white elbow to the other end and secure it with the hose clamp provided. Fit the white
elbow fitting to the outlet of the pump and finger tighten.
FITTING INSTRUCTIONS:
Position the sprayer to minimise contamination to the operator. With the pump mounted away
from operator the risk of contamination due to hose failure can be minimised. It is recommended
that the sprayer be securely attached to any ATV or other vehicle.
Refer to manufacturer’s
instructions for appropriate load limits and fitting positions.
Note: 1 litre of water = 1 kg.
Never fill spray tank to a capacity beyond the specified overall weight limits set by your vehicle
manufacturer. Recesses in the top of the tank allow for tie down straps. When fitted these should
be firmly secured to approved attachment points on the ATV or other vehicle.
The sprayer should be mounted centrally and as near to the centre of gravity of the ATV as possible.
It should not protrude to cause an obstruction.
PUMP HOSE ANCHOR:
We have supplied a Plastic Hose Tie to protect the pump housing or hose fitting from possible
damage caused when the hose is pulled tight or over stretched.
The hose can be tied against the switch bracket as shown in the diagram below without restricting
the flow.
Installation
Do not exceed the vehicle manufacturer’s specified safe load and carrying
capacity.
