Innovative Solar Solutions| 2917 State Hwy 7, Bainbridge, N.Y. 13733 | Ph: 800.786.0329 | www.SiliconSolar.com
Filter cabinet should be washed with clean water periodically to make sure there is no dirt block the
holes.
If the pump impeller gets stuck, pull off the filter cabinet. Open the impeller cover by releasing the strew
on it, and then clean the impeller with clean water
How To Use:
Submerge the solar fountain pump below the water surface, while still keeping the nozzle above the
water. So as to force water to flow into the filter cabinet, and allow air to escape from the pumping
system
Allow the solar fountain pump to operate for a minute before attaching sprinkle head onto the nozzle.
How To Replace The Pump:
1.
If any, remove nozzle and sprinkle head from the base.
2.
Release the screws which hold the pump to the base, and remove the old pump from the base by pulling
it upwards
3.
Release the screws on the junction cabin, and remove the cabin cover.
4.
Locate the connection of the two wires. (One wire from the old pump, and the other one from base).
The connection is usually protected by a insulate tube and white resin
5.
Cut off the connection and get rid of the old pump
6.
Cut two pieces of insulate heat shrink tube with a length of 2cm each, and them into the two wires
(one red, one black) coming from the base. One tube for each wire
7.
Connect the wires coming from the base to the wires from the new pump. Please connect with correct
polarity. Red wire to red wire, and black wire to black wire
8.
Cover the connection with insulate heat shrink tube, and shrink the tube by blowing hot air until it is
attached tightly to the wires. A hair dryer is recommended for such purpose.
9.
It is recommended to soak the connection with silicone to prevent water from seeping into the
connection
10.
Put all the wires back into the junction cabin, and secure the cover with screws
11.
Secure the new pump to the base with screws
