Silicon Radar SiRad Easy, Manual, Page: 13 / 14

- 13 -
Evaluation Kit SiRad Easy® r4, SiRad Easy® & SiRad Simple®
User Guide Version 2.5 19-Nov-2021
6 Communication Interfaces (SER1/SER2)
Please visit the
Download Area for the drivers, software download links and software requirements.
The connection parameters for the Serial/USB ports SER1 and SER2 are: 8 bit, 1 stop bit, 1 start bit, now flow
control, 230400 or 1000000 baud (depending on the flashed firmware).
SER1 – Serial/UART is available on the external header (J1), lines MR and MT.
SER2 – Serial/USB is available on the USB port (only on SiRad Easy®).
You can connect to both SER1 and/or SER2 using a terminal program such as
Realterm , PuTTY or third-party
software instead of the COM2WebSocket Tool / WebGUI . You should see plenty of protocol output from the
evaluation kit as shown in Figure 20 (left) after connection. Now you can send commands to the evaluation kit.
The communication protocol is described in the
Easy r4 , Easy and Simple Protocol Descriptions.
Figure 20 Terminal output of the evaluation kit (left) and Octave (right)