S i 5 x x - E V B
2
Rev. 0.1
1. Introduction
This document describes the operation of the Silicon Laboratories Si5xx evaluation kit. The Si5xx-EVB kit refers to
the evaluation board hardware intended for customer evaluation of the Si5xx single/dual frequency XO/VCXO. The
Si5xx-EVB kit contains the following:
Si5xx-EVB Hardware
Si5xx-EVB User Guide (this document)
The Si5xx-EVB evaluation board can be used to evaluate all the single and dual frequency Si5xx XO/VCXOs
offered by Silicon Laboratories
:
1.1. Quick Start
1. Install an Si5xx device on the board.
2. Verify the jumper settings are correct.
3. Connect external power cable to the EVB (set voltage according to how the part was ordered).
Table 1. Si5xx XO and VCXO Device Evaluation Board Selector Guide
Part #
Type
Devices
Supported
Packages
Supported
Output Format,
Temp Stability,
Tuning Slope
Supported
Frequency
Range
Si5XX-EVB
Fixed Fre-
quency XO/
VCXO
Eval Board
Si510/511
Si512/513
Si515/516
Si530/531
Si532/533
Si550/552
Si590/591
5 x 7 mm, 6-pin
3.2 x 5 mm, 6-pin
3.2 x 5 mm, 4-pin
LVPECL
CML
HCSL
LVDS
CMOS
Dual-CMOS
100 kHz to
1417 MHz
Note:
Si5xx samples must be ordered separately from the Si5xx-EVB.
Summary of Contents for Si5-EVB Series
