S e n s o r P u c k
Rev. 1.0
13
Next, set the debug mode to ‘Out’ in the dialog shown below.
Figure 14. Kit Manager Dialog
To use the development kit subsequently without the puck, it is necessary to revert this setting before
disconnecting the puck.
To open the source code in Simplicity Studio, launch the Software Examples wizard by clicking on the Software
Examples tile (see Figure 13). Then select Sensor_Puck as the kit. Click ‘Next’ and select the sensor_puck source
code.
This will load the source code in the Silicon Labs IDE where it can then be viewed, edited, compiled, and
downloaded from within Simplicity Studio. The details of doing this are beyond the scope of this document.
Note:
Sensor Puck is planned to be supported in V3.0 of Simplicity Studio. Prior to V3.0, the source code will be provided at
www.silabs.com/sensor-puck
. To load the project into Simplicity Studio, use the steps in the readme document in this link
instead of the Software Examples wizard.
