CP2201-EK
4
Rev. 0.1
5. If the network does not have a DHCP server, then the CP2201EB will search for approximately 35 seconds
before going into static IP address mode. While searching, the yellow led will be blinking fast. After going
into static IP address mode, Netfinder will display information about the device in a window with a yellow
background. Select the device by
clicking inside the yellow area
and
pressing the Assign IP button
as
shown in Figure 5.
Figure 5. Static IP Address Mode
6. Enter the IP address, subnet mask, and default gateway (if known) into the ‘Assign IP Address’ dialog and
press
OK
. See Appendix A for information on how to configure the PC with a static IP address and how to
select a static IP address for the CP2201EB. A windows command line window should appear, ping the
device at its new address, then close. Programming is successful when the progress bar stops and gives
the message “Success - Device Programmed” as shown in Figure 6.
.
Figure 6. Assign IP Address Dialog
