C P 2 11 0 - E K
2
Rev. 0.3
4. CP2110 Hardware Interface
Connect the CP2110 evaluation board to a PC as shown in Figure 1.
1.
Connect one end of the USB cable to a USB Port on the PC.
2.
Connect the other end of the USB cable to the USB connector on the CP2110 evaluation board.
3.
Connect one end of the RS-232 serial cable to the DB-9 connector on the CP2110 evaluation board.
4.
Connect the other end of the RS-232 serial cable to the target serial device.
Figure 1. Hardware Setup
CP2110 EK
Serial Device
RS232
CP2110 HID USB-
to-UART Bridge
USB
