4.3 EZR32 Reset
The EZR32 Wireless MCU can be reset by a few different sources:
• A user pressing the RESET button.
• The on-board debugger pulling the #RESET pin low.
• An external debugger pulling the #RESET pin low.
In addition to the reset sources mentioned above, a reset to the EZR32 will also be issued during Board Controller boot-up. This means
that removing power to the Board Controller (unplugging the J-Link USB cable) will not generate a reset, but plugging the cable back in
will, as the Board Controller boots up.
UG191: EZR32HG 434 MHz 10 dBm Wireless Starter Kit User's Guide
Power Supply and Reset
silabs.com
| Building a more connected world.
Rev. 1.01 | 15
