Silicon Graphics InfiniteStorage 6120, User Manual

Page: 67 / 94

Remote Management of InfiniteStorage 6120
0 0 7 - 5 5 3 3 - 0 0 1
57
3.6 Remote Management of InfiniteStorage 6120
The InfiniteStorage 6120 can be managed locally through the RS-232 interface or remotely via SSH.
The CLUI is the same regardless of the management interface (RS-232 or SSH).
3.6.1 Network Connection
Connect the Telnet port on the back of the controllers to your Ethernet network
(Figure 81)
. Then
configure the network interface as described below.
NOTE : Currently, the InfiniteStorage 6120 does not support network configuration
protocols such as DHCP or BOOTP.
3.6.2 Network Interface Setup
UI SHOW NETWORK_INTERFACE [LOCAL|REMOTE] * displays the list of the network interfaces
with their associated controller IDs and devices
(Figure 82)
. LOCAL gives you information on the
controller that you are currently logged into. REMOTE gives you information from the other controller
in the pair.
To change the network interface settings on the controller you are connected to, enter this command:
UI SET NETWORK_INTERFACE LOCAL IP_ADDRESS=<ip_address> IP_MASK=<netmask>
IP_GATEWAY=<gateway>
where <ip_address> is an address appropriate to the local network. The netmask and gateway values
can also be entered
(Figure 83)
.
Enter command
SHUTDOWN SUBSYSTEM RESTART
to restart the controllers and make the changes
take effect.
3.6.3 Logins
By default, the login name is
user
and its password is
user
.
Only one SSH session is permitted at a time. Once a SSH session is initiated, the RS-232 console
switches to a CLI sub-shell. The SSH client should be using port 22 with its local echoing function
disabled.
Figure 81. Connectors on Controller
EXPANSION CLI
LINK SPEED
PORT
2
PORT 1
Telnet Connector
CLI Connector
Figure 82. Current Network Interface Settings Screen
RAID$ ui show network_interface local *
Network device id 0
address 10.32.31.31
netmask 255.255.240.0
gateway 10.32.16.2
RAID$ ui set network_interface local ip_address=10.32.31.31 ip_mask=255.255.240.0 ip_gateway=10.32.16.2
NETWORK_INTERFACE 0 set with STATUS=’Success’ (0x0)
Figure 83. Set Network Interface Example