Silicon Graphics 320, Owner'S Manual

Page: 58 / 152

42 Chapter 4
7. Set the jumpers on the drive. To set the jumpers, refer to the
labeling on the back of the drive or to the documentation that
came with the drive.
■
If you are installing a system drive, set the drive jumpers to
Master.
■
If you are installing an option drive, set the drive jumpers to
Slave.
If you are installing SCSI drives, set the system drive to SCSI ID 0
and the secondary drive to a number from 1 to 15, excluding
number 7 and any numbers taken by other SCSI drives.
8. Remove four screws from the bag of screws located inside the
side panel. (Refer to Figure 4-2.)
9. Insert the drive into the bracket. If you are installing a system
drive, install it in the bottom slot.
10. Insert and tighten the four screws, as shown in Figure 4-12.
Figure 4-12 Attaching an Internal Hard Drive to the Drive Bracket