Silicon Graphics 230, User Manual

Page: 88 / 148

72 007-4263-001
3: System Board
Error Messages
Do not continue using the computer if you receive an error message of any type. Note the
message and take corrective action. This section explains the different types of error
messages and corresponding corrective measures.
There are two general types of error messages:
• Software error messages
• System error messages
Software Error Messages
Software error messages are returned by your operating system or application. These
messages typically occur after you boot the operating system or when you run your
applications. If you receive this type of message, consult your application or operating
system manual for help.
System Error Messages
A system error message indicates a problem with the computer itself. A message of this
type normally appears during the power-on self-test, before the operating system
prompt appears. Table 3-4 lists some of the system error messages and the corrective
action to take.
Table 3-4 System Error Messages
Message Action
CMOS Battery Bad Replace the lithium battery or call for support.
CMOS Checksum Error Run Setup a .
CPU BIOS Update Code
Mismatch Call for support.
Diskette Drive Controller
Error or Not Installed
Floppy Disk Controller
Error Check and connect the floppy cable on both the floppy drive
and system board end.