Silicon Graphics 230, User Manual

Page: 70 / 148

54 007-4263-001
2: Installation of Customer Replaceable Components
Post-installation Instructions
After completing the installation of customer replaceable components, follow these
instructions to ready the system for operation:
1. If your installation involved the removal of the bezel, follow these steps to replace
the bezel:
• Locate the four tabs on the right side of the bezel, as shown in Figure 2-31.
• Place the right side of the bezel on the chassis so as to insert the four tabs in their
respective slots, as shown in Figure 2-31.
• Push the left side of the bezel towards the chassis until all four tabs on the left
side of the bezel are securely snapped onto the chassis.
Figure 2-31 Replacing Bezel
Right side