88
BR-500AC User's Manual
5-4. Address Management Table
In
Multi-Client Mode
, up to 16 non-wireless devices can be shared over network by saving
combination of MAC address and IP Address of such devices to BR-500AC.
The combination information is saved automatically when BR-500AC started communication
with non-wireless devices, but if the address management table feature is used, it is possible
to manually add or delete the combination information.
About Address Management Table Feature
How to register combination of MAC address and IP address will differ depending on
whether the address management table feature is enabled or disabled (ON/OFF).
If this feature is ON, the management table information is used for the combination
information (MAC a IP address) of non-wireless devices to connect to BR-500AC.
The addresses are automatically registered to the management table when the devices are
added while BR-500AC is active. When this function is OFF, the management table setting is
not used.
- Only unicast address is supported for MAC address and IP address
.
- BR-500AC checks the existence of device information to save at 5 sec interval. If BR-500AC is turned off before
the saving process is completed, the device information is not saved in the address management table.
- Up to 16 sets of combination information can be registered to the management table. If 16 sets of
combination information are already registered, new one cannot be added. Delete unnecessary
information then.
TIP
Summary of Contents for BR-500AC
