Silex technology BR-500AC, User Manual

Page: 27 / 128

3. Before You Begin
21
Multi-Client Mode
Use this mode when you connect multiple non-wireless devices to BR-500AC.
By using a HUB on the LAN port, up to 16 devices can be connected.
For wireless LAN connection, the MAC address of the BR-500AC’s wireless module and the
IP address of the connected device will be used.
HUB
Up to 16 non-wireless devices can be
connected using a HUB.
BR-500AC
Access Point
(Wireless Router)
Printer
Monitoring
camera
(Non-wireless devices)
MAC address of the BR-500AC’s wireless
module and IP address of the connected
device are used for wireless connection.
- The devices with multiple MAC addresses cannot be used.
- When Multi-Client Mode is on, only ARP, IPv4 and IPv6 are supported. The following protocols are not
supported.
- Protocols with a mechanism to check the source MAC address
- Protocols with a system to run with a MAC address that is contained in the packet data
TIP