Silent Gliss Ltd.
0939 Multi room Handheld Controller
: User guide Page 2 of 7
If the blinds are of the Venetian type the motor control module may have been set with ‘momentary’ action. In momentary mode the open/close keys will
allow short presses to change the louvre tilt and releasing the key after a short time will stop the change in tilt. To fully open/close the blind keep the
appropriate key held until the control module ‘latches’ (default setting for this is 1.5 seconds) and then release, the blind will now travel to fully
opened/closed without any further input.
To access individual blind control press the up/down keys to scroll between blinds, or press ‘All’ to return to the Overall control screen.
To change rooms press the ‘Room’ key (to access Screen C2) and then use the up/down keys to scroll between rooms, use the Enter key to select.
Grouped Rooms
– It may be desirable to have rooms that have a logical association ‘grouped’ with the shortcut key giving quick navigation between these
rooms. An example would be an open plan kitchen/lounge area where the blinds in each room have been set as different rooms to give separate room control
when using ‘Overall Open/Close’ but the user may well want to access both rooms quickly. Once a room in a group is selected the shortcut key will scroll
through all the rooms in the group, if there are only two rooms this action will appear as a ‘toggle’.
Configuring the 0939 manually
– Before
configuring the 0939 the Silent Gliss system to be controlled needs to be programmed, once this is complete the
0939 can be set-up to control the desired rooms with any required channel and scene information.
Entering setup mode –
From the Room select screen (C2) press the left right and shortcut keys simultaneously. You cannot Enter set up from all screens.
To exit setup mode press quit twice
The following notes should be read whilst referring to the Main Setup Menus pages of this manual. The notes assume that the handset is in setup
mode (see above).
To assign House Address and Enable Rooms the user must know the numbers assigned to the receivers to be controlled. This will be available either
from the installer or by examining the Address Switch settings on a Silent Gliss wallplate and referring to the wallplate manual.
Setting the House Address
– To Enter the House address use the down key to navigate to Screen D2 (Choose House), press Enter to display the current
house (Screen D21) and then scroll up or down to the desired house number and press Enter.
Note: The following functions are the most commonly accessed functions of the handset
