Page 4
V1.1 07/04
Surface fixing with no back-box
Take the universal backing plate and screw this to the wall
(screws not included) using the fixing slots. Rotate the patress
so that the bossed inserts are aligned horizontally and then,
using the 2 x self-tapping screws, fix the patress to the universal
backing plate taking sure not to over-tighten the screws. Insert
the PCB retainer into the patress and then using the 2 x 6mm
fixing screws, secure the front plate to the patress fixing the
screws through the PCB retainer and into the bossed inserts.
Surface fixing to European back-boxes.
For fixing to European DIN or French standard back-boxes the
Silent Gliss universal backing plate has been designed so that
two of the fixing slots match European DIN standard back-box
fixings and two match standard French back-box fixings. To
mount the assembly, orientate and mount the universal backing
plate as applicable (screws not provided) and then follow the
instructions for ‘Surface fixing with no back-box’.
Care and maintenance
Battery replacement
The Silent Gliss series of wall-switches are designed to be
powered by batteries. The designed battery life is better than 3
years (based on 30 button presses daily) but the batteries will
eventually need replacing. In normal use the LED on the front
panel illuminates momentarily when a button is pressed to
indicate that a (radio) transmission has been made. When the
batteries are approaching the end of their useful life the LED will
continue to blink after a button has been pressed. When this
starts to happen the batteries should be replaced as soon as
possible.
Always use two CR2016 type batteries.
To replace the batteries unscrew the front plate and remove the
PCB retainer, taking care not to damage the aerial (note that
when flush mounted the aerial may be located in a hole outside
the back-box). Remove the rear cover and carefully slide out the
batteries. Replace with new batteries ensuring that the positive
(+) terminal makes contact with the battery clip and the negative
(-) terminal with the pad on the circuit board.
To ensure reliable operation always ensure that battery contacts
and battery surfaces are kept clean of any grease, moisture or
other contamination.
Warning
Lithium batteries may explode if handled incorrectly.
Always dispose of used batteries in accordance with
manufacturer’s recommendations.
Star Lane, Margate,
Kent CT9 4EF, England.
Telephone: 01843 863571
Sales Fax: 01843 864503
Admin Fax: 01843 861226
E-mail:
Web site: www.silentgliss.co.uk