IM_FULL_55SL_REV_B
17
RPM LEARNING
Note:
To set RPM learning, the White/Red wire from the 14 pin connector must be connected properly.
1. Enter Start Feature
“D”
Program mode.
2. Press the + buttons together to set “Tachometer Checking Type” on (2-chirps).
3. Press the button to confirm RPM learning mode on (1-chirp).
4. Start the vehicle with the ignition key. While the engine is running the parking lights and LED will flash. If they flash,
proceed to point 5. If they do not flash, turn the ignition key to the
“OFF”
position and press the button to exit
“D”
programming mode. Check or re-connect the White/Red wire from the 16 pin connector and re-try.
5. Press and hold the valet button (2-3 sec) until a long chirp is heard and the LED stays on solid for 2 seconds.
The RPM signal learning is complete.
6. Stop the engine using the ignition key.
RETURN TO START FEATURE FACTORY DEFAULT SETTING
Press the button once and then press + buttons together for 6 seconds. There will be a reset confirmation of
3 long chirps and 3 parking light flashes. This confirms that programmable feature settings in charts
“C”
and
“D”
are
back to their default settings.
TROUBLE SHOOTING
There are 5 reasons why the remote start button will not respond from the transmitter.
1. The Black/White Neutral Safety wire is not grounded. Must be grounded to start.
2. Hood Pin switch White/Black wire has a ground present. Must not show ground to start.
3. Brake pedal switch White/Violet has 12 volt present. Must not show 12 volt to start.
4. The system is in Valet mode.
5. The remote start feature programming has not been programmed to start the vehicle.
The remote start must be programmed how to start the vehicle.
SHUTDOWN DIAGNOSTICS
The unit has the ability to report the cause of the last shutdown of the remote start system.
Enter:
1. Turn the Ignition ‘switch to
“ON”
position.
2. Press the button on the transmitter.
3. The LED will now report the last system shutdown by flashing for one minute in the following grouped patterns:
LED
Flashes
Shutdown Mode
1
(-) Safety Shutdown input (Hood)
1. Close the hood.
2. Check White / Black wire connection.
2
(+) Safety Shutdown input (Brake)
or Neutral Safety Switch input fail.
1. Check White/ Violet wire connection.
2. Move the Enable Toggle Switch to
“ON”
position. (If installed.)
3. Move the gear selector to
“Park”/ “NEUTRAL”
position.
4. Check Black/White wire connection.
3
No RPM or
Low Voltage.
Tachometer Checking Type:
Check White/Red wire connection
Voltage Checking Type:
Program the “CHECK LEVEL” from
“Hi Check Level” to “Low Check Level”
5
Over-rev
6
System timed out
7
Transmitter
8
Tach. Signal has not been learned
Re-learning the RPM
(Start Feature D – 2 / 3)
