Silca UC 199, Operating Manual

Page: 69 / 107

5.10 MACHINE MESSAGE
5.10.1 ERROR MESSAGE
ERROR 1
Key gauge out
of place !
• During the reading or decoding cycle the machine’s optical reader verified that the key gauge had not been
lowered
ERROR 2
Optical reader
not activated !
See operating manual.
•
This message indicates that there is a fault in the optical reader or that something is obstructing its laser beam
before starting the reading or decoding cycle.
ERROR 3
Key cannot
be copied !
•
The key cannot be cut by UC199 during the reading stage and at this point.
5.10.2 ATTENTION MESSAGES
ATTENTION
Depth limit
exceeded !
•
During the cutting cycle one or more depth exceeded the maximum limit. These depths are automatically
aligned to the maximum permitted depth.
ATTENTION
Turn off machine
and fit clamp:
L1
•
A gauging operation that requires the Loader Unit (L1=Automatic clamp) is about to take place but the unit is
not detected. Remedy with: Maintenance (5) > Loader Unit (3) (see Ch. 5.8).
ATTENTION
Turn off machine
and fit clamp:
L100
•
A gauging operation that requires the standard cutting clamp (L100=Standard clamp) is about to take place
but the clamp is not detected. Remedy with: Maintenance (5) > Loader Unit (3) (see Ch. 5.8).
Operating Manual
UC199
Copyright Silca 2012
65