TARGA 2000
Operating manual - English
Copyright Silca 1999
7
1
TRANSPORT
The TARGA 2000 key-cutting machine is easily transported and is not dangerous to handle.
The packed machine can be carried by one person.
1.1
Packing
The TARGA 2000 key-cutting machine is consigned in a strong cardboard box, the dimensions of
which are shown in fig. 3, designed to protect the machine even when it is stored for long periods.
Inside the box, the machine is completely enclosed in two expanded polystyrene semi-shells (fig.
3).
The box and shells ensure safe transport for the machine and the detached separate parts.
Fig. 3
1.2
Transport
It is advisable to use the packing every time the machine is transported, as this will avoid knocks
causing damage to the machine, people or things.
1.3
Unpacking
To remove the machine from the packing box:
1) cut the straps with scissors and remove,
2) prise off the staples,
3) it is advisable to open the box without damaging it so that it may be used again (removals,
dispatch to manufacturers for repairs or servicing),
4) check the contents of the box, which should comprise:
- 1 clamp carriage;
- 1
TARGA 2000
key-cutting machine packed in its protective shell;
- 1 chippings tray;
- 1 tool tray;
- 1 carriage lever handle;
- 1 power cable;
- 1 power safety device (supplied with 230V machines);
- 1 set of documents, including: operating manual, spare parts list and guarantee;
5) remove the machine from the protective shell.
1.4
Machine handling
When the key-cutting machine has been unpacked, place it directly on its workbench.
This operation can be carried out by one person, firmly holding the base, and no other part, to lift
and carry the machine.
500
580
40
0
shells
