4 MACHINE REGULATION AND UTILIZATION
4.1 Checking and calibration
The cutting tool on the machine is the part used to cut the key blanks and should be periodically checked and
replaced, if necessary.
Every time the cutting tool is changed, and during periodical operational tests, check calibration.
4.2 Calibration
The SPEED key-cutting machine requires two types of calibration:
axis
and
depth
.
Axis calibration:
Axis calibration is regulation of the space between cutting and the stop (Fig.12 and Fig.13).
The axis setting for the SPEED is fixed and is established on assembly in our workshops.
Fig.12
Fig.13
Operating manual
SPEED
Copyright Silca 2013
12
