Siku PTC-21 Operating Instructions Manual Download Page 2

 

order to avoid a hazard. 

4.

 

The  heater  must  not  be  located  immediately  below  an  electrical 
socket.  The  electrical  socket  must  be  equipped  with  earth  wire,  its 

capacity should be 250V~10A or exceed 250V~10A. The socket and 

the power plug should be in good connecting condition.

 

5.

 

If nobody is in using or you are repairing the heater, please pull off 

the plug. 

6.

 

Please don’t touch the heater by the wet hand or other conductor. 

7.

 

If motor is not working properly, please stop it immediately.   

8.    During  using  the  heater,  please  do  not  open  the  door  or  window 

continually otherwise it will influence the heating effect. 

9.    If want to shut off the heater,  press the  on/off switch to off, then the 

heater will keep the fan working 30 seconds until it blowing out cool 

wind,  then  the  heater  will  stop  working,  and  you  may  pull  off  the 

plug. 

11. Timer sets the heater working time. 

12. Remote control, please use 2 batteries. 

13. The battery must be removed from the appliance before it is scrapped. 

14. The battery is to be disposed of safely. 

15. The heater must be installed at least 2 m above the floor. 

16.  If  the  heater  needs  repair,  please  ask  for  special  person  or  our 

company authorized maintenance department. 

17.

 

This appliance can be used by children aged from 8 years and above 

and  persons  with  reduced  physical,  sensory  or  mental  capabilities  or 

lack of experience and knowledge if they have been given supervision 

or  instruction  concerning  use  of  the  appliance  in  a

 

safe  way  and 

understand  the  hazards  involved.  Children  shall  not  play  with  the 

appliance.  Cleaning  and  user  maintenance  shall  not  be  made  by 

children without supervision. 

18.

 

Children of less than 3 years should be kept away unless continuously 

supervised. 

19.  Children  aged  from  3  years  and  less  than  8  years  shall  only  switch 

Summary of Contents for PTC-21









Reviews: