Hand dryer
1.Bolt
2.Cover
3.Sensor
4.Outlet
Fig. 1
Fig. 2
Mounting holes for the
base plate
5. Screw anchors
6. Base plate
7. Screws
8. Adjustment screw for
operational sensitivity
Fig. 3
9. Hole in base plate
10. Terminal for power supply
11. Infrared sensor cable
12. Wrench
Fig. 4
Thank you for having chosen our durable and reliable hand dryer, operated by an infrared sensor. With an air speed of
30m/s and flow-rate of 4.5m3/min, the provision of super heating protection and a streamline metal cover, it will dry
your hands quickly and efficiently. Its adjustable 360° nozzle angle enables you to use it not only as a hand, but also
as a hair dryer. It is the ideal choice for hotels, offices, youth hostels or other public or private restrooms, or anywhere
where an efficient, dependable dryer is needed.
GENERAL
INSTALLATION INSTRUCTIONS
•
A two-pole safety switch should be hard-wired into the electrical circuit between the dryer and the power supply;
the terminal size should be larger than 3mm
•
The dryer must be properly grounded.
1. Disconnect the cover in the (4), (3), (2), (1) order indicated in fig. 4. Do not apply too much pulling tension to the
connecting wire between the cover and the inside connection when disconnecting the cover.
2. Determine the correct location for the bolt holes to fix the ground plate as shown in fig.2, then drill holes of 8mm
diameter, and 35mm depth.
3. Fix the base to the holes using the attached plastic screw anchors and screws (fig. 3)
HAND DRYER USER INSTRUCTION