Quick Start Guide
MA508 · Date
23.05.2017 · Art.
No.
89052 · Mod.
status
304/16
SIKO GmbH
Weihermattenweg 2
79256 Buchenbach
www.siko-global.com
Phone
: + 49 7661 394-0
Fax
: + 49 7661 394-388
Service
MA508
Electronic display
For detailed documentation please refer under
http://www.siko-global.com/en-de/service-downloads/download-products
General information
Prior to installation, including in hazard areas, read the Installation instrunc-
tion (download from the internet). It contains the safety instructions, hints
and technical data to be observed during installation. Subject to change with-
out notice.
Caution
In order to ensure reliable functioning of this product, take care to transport,
store, position and mount it appropriately. Exercise care when you operate and
maintain the device. Only properly qualified personnel is authorized to install
and operate this product.
Safety information
It is important for safety reasons that you read and understand the below
instructions before you install the system:
•
Installation, connection, commissioning and maintenance shall be done by
properly qualified personnel.
•
It is the responsibility of the customer to ensure that the personnel con-
cerned read and follow the instructions and directions of this Guide and of
the User information.
•
It is the responsibility of the customer to ensure that the electronic display
is correctly connected and configured.
•
Only personnel specifically trained by SIKO shall execute repair and mainte-
nance work.
Mounting of the electronic display
For panel mounting we recommend the following dimensions:
69
49
35
74
≤R
5
for screw M3
Mounting of the magnetic sensor
The sensor senses the incremental travel information of the MB500/1 magnetic
tape.
The magnetic sensor, L versions, is mounted by means of the two attached
screws via the ø3.5 mm through holes. Fastening torque = 0.25 Nm.
Mounting the magnetic tape
Stick the magnetic tape level to the mounting surface or the distance to be
measured. Unevenness impairs measuring accuracy.
Mounting steps:
•
Clean mounting surface
1
carefully.
•
Remove protective film
2
of the adhesive tape
3
.
•
Stick down the magnetic tape
4
.
•
Clean surface of magnetic tape carefully.
•
Remove protective film
6
of the cover tape
5
.
•
Fix cover tape (both ends should slightly overlap).
•
Also fix cover tape's ends to avoid unintentional peeling.
5
1
2
3
4
6
Notice!
The tolerance and gap measures must be observed over the whole measuring
length.
0.
1 ... 2 mm
Gap sensor/magnetic strip
<1°
<3°
active side
Maximum alignment error
<3°
Direction of
outgoing cable
PE-connection (cable shoe
for M3 only with sensor
cable length >0.3 m)
Travel direction
positive counting direction
±2 mm
Travel direction
positive counting
direction
0.
1 ... 1.5 mm
≤1 mm
≤30°
active side
Electrical Installation
The location should be selected to ensure that no capacitive or inductive inter-
ferences can affect the electronic display or the connection lines!
•
When mounting the system keep a maximum possible distance from lines
loaded with interference. Use screening shields or metallized housings.
Connection of power supply
By an internal Battery powered.
Caution
As soon as the battery voltage falls below a defined value, this will be signalled
by a symbol on the display. On this stage, the functioning of the electronic dis-
play is ensured for a limited time. However, the battery should be replaced by
SIKO as soon as possible.