Siko MA01/1 SA04 User Information Download Page 12

Page: 12 / 16

1 2

MA01/1 SA04

Datum 30.11.2001

Art.Nr. 79871

Z.Nr. 8699091

Änd.Stand -/-

6. Operation / programming

The display can be run in 3 operating modes:

• Programming mode: to program the display
according to the application

• Input mode: for subsequent parameter modi-
fication.

• Display mode: to display the values measu-
red.

The five membrane keys on front of the display
are used to program and operate the display.
Depending on the operating mode, these keys
can have additional functions (see chapter 7
and 9). The keys are pressed singly or in pairs
(two together).

1. Programming
2. Select ‘value’
3. Select ‘digit’
4. Store value
5. ON / OFF

Fig. 8: Display and membrane keypad

7. Programming mode

The display MA01/1 is pre-programmed to stan-
dard values at our works. If the order defines
customer-specific parameters (configuration)
these will be pre-programmed at SIKO. In this
case the MA01/1 will be supplied with a list
showing the pre-programmed values.

For value modification / programming, switch to
programming mode (see below).

Parameters can be modified and checked at any
time. They are stored in a non-volatile memory.
The parameters for MA01/1 with 1 channel and
of MA01/1 with 2 channels (ie. for 1 or 2 sensors)
are not identical. The differences can be seen in
the parameter list. The following tables show
each parameter’s designation, function and va-
lue range.

To enter into programming mode:
Press key

for at least 5 s.

To leave programming mode:

Automatically, if no key has been pressed during
approx. 30 s or if you press

until the end of the

parameter list is reached.

To scroll the parameters:
Press key

To modify parameters:
Use keys

and

To store modified parameters:
Press key

; the display will shortly show the

message "-Sto-"

8. Parameter description

At the end of this user information brochure you
will find a detailed list showing all parameters,
their programming range and examples.

(in english language, parameter _LAn_ = "E")

Display

Designation / description

"choice"

SEnS 1

Sensor 1: The following parame-
ters up to '_dIr_' refer to the first
sensor input
(only displayed in case of a 2-
channel MA01/1).

SEnS 2

Sensor 2: The following parame-
ters up to '_dIr_' refer to the
second sensor input (only display-
ed in case of a 2-channel MA01/1).

_rES_

Resolution: Determines the
resolution of the display. Parame-
ter "FrEE" allows the programming
of a calculating factor.

_FAC_

Calculation factor (only available, if
‘Resolution’ has been programmed
to "FrEE" before): Used to obtain
for example an angle display.
Basis is the maximal possible
resolution of 1/100 mm. The
calculation factor "FAC" which has
to be programmed results from:
FAC = 10 x meas. range / total
travel distance [1/100 mm]
Example: Angle measurement on
a circular disk with a display range
of 0 ... 180°; display in 1/10
degrees; circumference of the
circular disk 942,48 mm; hence
total travel distance 471,24 mm;
FAC = 10 x 1800 / 47124 =
0,38200