EtherHaul™ 8000 Installation, Operation and Maintenance Manual
Page 26
2.8
Connecting the Cables
The following figure shows the radio interfaces. There are three line interfaces
available:
1GE: 802.3ab (RJ45, Cat5e or better cable), for PoE In and as 1G line interface
10GE combo port: 802.3an/bz (RJ45, Cat6a or better cable) or SFP+ (SMF or
MMF)
1. DVM Probe Interface (AUX)
5. Ethernet port #1 RJ45 (PoE In)
2. Reboot button (press for 10 seconds for factory settings reset)
6. DC In
3. Ethernet 10G SFP+
7. Electrical Ground (GND)
4. Ethernet 10G 802.3an RJ45
8. Antenna Interface
Figure 2-7 Front Panel Details
Caution:
Use only Class 1 Laser SFP which is safety approved to IEC 60825 and which is
CDRH registered
2.8.1
Power Supply Notes
2.8.1.1
DC Power
The DC power input range of the radio is 42 - 57 VDC.
The DC supply should be limited to 2A to avoid surges and possible damage to
the radio. For that, use limited power supply or circuit breaker (fast-blow fuse).
The circuit breaker is the disconnecting device, and should be readily accessible.
