3
Hardware Installation
General instructions for installing the card are provided
below. Since the design of computer cases and
motherboards vary, refer to your computer’s reference
manual for further information, if needed.
Static Electricity Discharge may permanently damage
your system. Discharge any static electricity build up in
your body by touching your computer’s case for a few
seconds. Avoid any contact with internal parts and
handle cards only by their external edges.
1.
Turn OFF the power to your computer and any
other connected peripheral devices.
2.
Unplug the power cord from the back of the
computer.
3.
Remove your computer’s cover.
4.
Remove the slot bracket from an available PCI slot.
5.
Set
JP1
jumper settings to the desired voltage only
if your serial device needs additional power from
the serial port. However, most serial devices do not
require additional power. For more information,
see
Figure 1
on page
2
. Skip this step if power is not
required.
6.
To install the card, carefully align the card's bus
connector with the selected PCI slot on the
motherboard. Push the board down firmly, but
gently, until it is well seated.
7.
Replace the slot bracket holding screw to secure the
card.
8.
Replace the computer cover and reconnect the power
cord.
Summary of Contents for Cyber 1S1P PCI
Page 10: ...10 Blank Page...
