HDMI HDBaseT 1x4 1080p Extender/Splitter - 150m
14
7. EDID Management
The Extended Display Identification Data (EDID) is used by the source device to match
its video resolution with that of the connected display. The source device obtains its
EDID from the first connected display as default setting. However, since displays with
different capabilities can be connected to the splitter, the EDID DIP switch can be used
to set the EDID to a fixed value.
The EDID switch on front panel:
Switch Status
Description
L.RES
The splitter reads EDID from all connected displays, and then
the source device will automatically obtain the EDID which
contain the lowest resolution.
PRESET
Switch to the preset EDID, and the preset EDID can be set via
the 4-pin EDID switch on rear panel. The factory default is 720p.
H.RES
The splitter reads EDID from all connected displays, and then
the source device will automatically obtain the EDID which
contain the highest resolution.
The 4-pin EDID preset switch on rear panel:
The 4-pin DIP switch on the rear panel allows you to set the EDID information that is
passed to the source devices. Use the following table to determine the settings for the
4-pin DIP switch for specific video resolution and audio capabilities. When in the down
position, each switch represents a 0, while putting the switch in the up position
represents a 1.
The below switch status is “0000”.