7
HARDWARE INSTALLATION
1. Connect a HDMI or DVI source (such as a Blu-ray Disc player) to the transmitting unit
AV-GM02X3-S1-TX.
2. Connect a HDMI or DVI display (such as a LCD TV) to the receiving unit AV-GM02W3-S1.
3. Connect IR Blaster/Receiver to both TX and RX units.
4. Connect a Cat-5/5e/6 cable between the transmitting and receiving units.
5. Make sure this Cat-5/5e/6 cable is tightly connected and not loose.
6. Plug in 5V DC power supply unit to the power jack of the receiving unit AV-GM02W3-S1.
7. Plug in 5V DC power supply unit to the power jack of the transmitting unit AV-GM02X3-S1-TX.
8. If you see flickering or blinking image on the display, please adjust the rotary control switch to
improve the cable skew. MAX stands for the strongest HDMI signal level for longest possible
transmission length while MIN stands for the weakest HDMI signal level for short transmission
length. Please adjust the signal level from MIN to MAX and stop turning the rotary switch
whenever the audio/video is playing normally. Inappropriate signal level setting may cause
overpowering issue that would shorten the product life significantly!
EDID LEARNING
Auto EDID Learning Mode
1.
Set “MODE” on the transmitting unit AV-GM02X3-S1-TX at 7
2.
Follow the instruction in [Hardware Installation] to set up the AV-GM02X3-S1
3.
The LED on the RJ45 of AV-GM02X3-S1-TX will dim and light again, which indicates the EDID
learning procedure is complete.
Manual EDID Learning Mode
1. Turn off AV-GM02X3-S1-TX and disconnect the Cat.5/5e/6 between AV-GM02X3-S1-TX and
AV-GM02W3-S1.
2. Connect the HDMI display to "HDMI IN" on the AV-GM02X3-S1-TX with a HDMI cable.
3. Set "MODE" on the transmitting unit AV-GM02X3-S1-TX at 7.
4. Turn on the AV-GM02X3-S1-TX.
5. The LED on the RJ45 of AV-GM02X3-S1-TX will dim and light again, which indicates the EDID
learning procedure is complete.
6. Unplug the HDMI cable from the display and follow the instruction in [Hardware Installation] to
set up the AV-GM02X3-S1 and enjoy the experience.
After you use "Manual EDID Learning" steps at Mode 7 on the TX, the "Auto EDID Learning"
function will be closed temporarily until you set the "MODE" on the TX to other mode and
then back to mode 7 again.
