SII TMI VD55C, Manual

Page: 19 / 35

・
The explanation here is only for the particular point of Cal.VD55C Tweezers
1.REMARKS ON INSTALLING THE BATTERY
1) After the battery is replaced with a new one or after the
battery is reinstalled following the repairing procedures,
Be sure to touch the short-circuit the AC terminal of circuit
block and the switch spring with conductive tweezers
to reset the circuit as illustrated at right.
2) When the battery replaced with a new one, the time information stored in the built-in IC and
the time indicated by the stopwatch hands do not correspond with each other.
Reset the stopwatch hands to "0" position following the procedure below.
If the stopwatch hands should move improperly, also follow the same procedure.
ORDER
Pull out the crown.
Keep the buttons "A" and "B" pressed at the same time
for 2 seconds, and then, release the buttons.
The stopwatch second hand move back and returned
to where it was.
Press button "A" or "B" to reset the stopwatch second
and minute hands to"0" position.
* By pressing button "A" , set the stopwatch 1/10 second hand.
* By pressing button "B", set the stopwatch second and minute hands.
Turn the crown to set the hour, minute hands to
the desired time, and push the crown back
to the normal position.
5
SII Products
Version-01
VD55C
TECHNICAL GUIDE
1
2
3
4
A
B