SIGURO SGR-SK-N610W, Translation Of The Operating Instructions

Page: 6 / 48

EN - 6
EN
TECHNICAL PARAMETERS
Input voltage
5 V
⎓
/ 0,6 A
Output 1.95 W
Built-in battery Li-Pol; 3.7 V; 700 mAh
Dimensions 190 × 26 × 26 mm
Weight 200 g
USE
Charging
Plug one end of the USB cable into the charging port and plug the other end into the
AC adapter (not included). Plug the plug into a properly grounded power outlet.
The LED light will flash red, indicating that the appliance is charging. When the LED
light turns blue, the appliance is fully charged.
If the LED lights up red during use or after switching on, the appliance must be
charged. In this case, the appliance will switch off automatically.
Charging time is usually 2.5 hours. The continuous operation time of a fully charged
appliance is approximately 90 minutes.
Inserting the attachment
Remove the attachment you want to use from the protective sleeve.
Insert the attachment into the hole in the head of the appliance until you feel
resistance. Make sure the attachment rotates freely.
If you need to replace the attachment, pull it out of the appliance head.
Warning: Always make sure the appliance is switched off before fitting or
changing the attachment.
Attachments and their use
1. The cone cutter is used for filing natural and acrylic nails. Easily shortens and
shapes nails. It is also suitable for removing dry skin around the nails.
2. The needle cutter is used to remove dry cuticles and helps remove dead cells from
the lateral nail folds.
3. The cylindrical cutter is used for filing natural and acrylic nails. It files the edges of
the nail and polishes all the grooves to make the nail surface smooth. It is also used
to clean the nail bed.
4. The polishing roller is used for filing and removing dead skin cells around the nail
bed and on the sides of the nail.
5. The felt cone is used to polish and smooth the nails after filing.
6. The ceramic cutter is used for quick removal of nail glue.
Warning: There is a risk of injury if handled incorrectly.