Instruction Manual ScrubberGuard
Servicing
106
14830E/2
9.4.4
Cleaning parts which come into contact with water
The following describes cleaning the parts of the ScrubberGuard that come into contact with
water:
WORKSTEP
ADDITIONAL INFO / IMAGES
1.
Interrupt the sample feed to the photome-
ter.
2.
Remove the inlet and outlet from the photo-
meter.
3.
Remove the optics unit on the photometer
according to Section 9.4.1 and place in the
recess (docking station).
Danger due to UV radia-
tion (on OilGuard SG only).
Use UV goggles and gloves.
4.
Loosen the screw connections X and Y and
remove the inlet pipe.
5.
Remove the outlet cone C by pulling it up-
wards.
6.
Clean the removed parts or replace if neces-
sary.
When doing so, also inspect the seal in the
outlet cone (arrow).
