-2-
220 VFW Avenue, Grasonville, MD 21638
TEL: (410) 827-- 8300 Fax:(410)827- 8866
[email protected] www.signtexinc.com
Signtex Inc
LIGHTING
Fixture Assembly
1. Note position of (2) J-Box MOUNT screws and insert (2) #8-32 x ½” PLUG sealing screws with nuts into
Canopy at unused locations.
2. Connect power supply wiring to building supply with standard wire nuts:
BLACK: 120-277VAC:
WHITE: Neutral.
3. Connect GROUND to J-Box
4. Connect optional NORMALLY ON control switch (SW) Wiring.
5. Connect the BATTERY plug. Insert power supply assembly in position and secure to J-Box with two #8-32
x 3/4” MOUNT sealing screws supplied and tighten to compress gasket evenly. DO NOT over tighten.
7. Place Lamp Housing Assembly over Canopy Plate and connect Lamp Plug.
NOTE: If AC power is OFF, the fixture will turn ON under battery power. To minimize battery
discharge, turn AC power ON after fixture is connected.
If fixtures remains in Emergency mode after AC power is applied, depress & hold test button
for one minute & release.
8. Insert Lamp Plug wiring sleeve through center hole in Gasket while placing Lamp Housing in position.
Tighten (2) #6-32 set screws to secure in position.
9. Turn ON building AC supply and operate test switch to confirm emergency operation. Batteries require 24
hrs for full charge. Operate control switch option where supplied to confirm normally ON operation.
GROUND
TO J-BOX
L N G
120/277 VAC
TEST SWITCH
& STATUS LIGHT
LAMP HOUSING
ASSBY
POWER
ASSBY
Black
Red
White
(2) # 8-32 x 1/2"
CANOPY PLUG SEALING SCREW
(2) # 8-32 x 3/4"
CANOPY MOUNT SEALING SCREW
BATTERY
PLUG
TOP MT
(OPTION)
OPTIONAL
NORMAL ON
CONTROL
SWITCH WIRING
(2) # 6-32 x 3/8
SET SCREW
LED Architectural Emergency Light with Battery Backup
Series MAEBB
Moonlite LED
™
5.15.03
