3
Use the correct Signode products for your application. If you need help contact your
Signode Representative.
Signode tools and machines are designed and warranted to work together with Signode
strapping and seals. Use of non-Signode strap, seals and/or manufactured or specified
replacement parts may result in strap breakage or joint separation while applying strapping
to a load or during normal shipping and handling. This could result in severe personal injury.
JOINT FORMATION
1. Before using this tool, read its Operation and Safety Instructions
contained in this manual.
2. The RCN-3435 and the RCN-1435 are double reverse notch
sealers. The N-1435, N-1444-50LSH and N-1457LSH are double
crimp sealers and the NS-1457-75L and the NS-250-65L are single
crimp sealers, although the single crimp sealers are usually
required to place two crimps per seal. If an NS-250-65L tool is
being used to crimp a 203 seal, then three crimps per seal are
required. Refer to the specifications at the back of this manual
for details. Properly notched or crimped seals will appear as
shown in the illustration. If the joint does not appear as shown,
then the operator must proceed as follows:
A. Ensure that the tool's operating instructions are being
followed before applying another strap.
B. Cut the strap off and apply another.
3. An improperly formed seal which does not have good notches or
crimps, could result in strap separation. Before moving any
package be certain that the seal is formed as shown. Inspect the
joint to make certain it appears as shown in the illustration. If
not, remove the strap and check the tool for worn or broken
parts. Repair the tool before applying another strap.
MOVING AND STACKING STRAPPED LOADS
Before moving or stacking any strapped load, follow all standard industry practices regarding safe
material handling procedures.
CUTTING TENSIONED STRAP
Using claw hammers, crowbars, chisels, axes or similar tools will cause tensioned strap to fly
apart with hazardous force. Use only cutters designed for cutting strap. Read the instructions in
the cutters manual for proper procedure in cutting strap. Before using any Signode product read
its Operation and Safety Manual.
TOOL CLEANING & LUBRICATION
Clean and apply a light weight machine oil to all moving parts on a weekly basis. Refer to the
Pneumatic Information shown in this manual for lubricant recommendations with regard to tool
operation.