Signode AL-12/38, Operation, Parts And Safety Manual, Page: 6 / 12

6
PACKAGE SURFACE
OPERATING INSTRUCTIONS, Continued
4. Return the sealer handle to its original position. At
the same time pull the tensioner handle all the way
back to disengage the feedwheel. The tool can be
removed from the tensioned strap by swinging the
rear of the tool to the operator's left. Inspect the
seal to make sure a proper joint has been formed.
Refer to the view, next page, for details.
JOINT FORMATION
!
Before using this tool, read its Operation and Safety instructions contained in this manual.
! This tool is a double notch type sealer. Each notch-joint must be inspected to make certain it
has four (4) good notches. A properly formed notch-
joint will appear as shown in the illustration. If the
notch-joint does not appear as shown, then the
operator must proceed as follows.
1. Make certain that the tool's operating
instructions are being followed before applying
another strap.
2. Cut the strap off and apply a new strap and seal.
3. An improper formed seal which does not have four (4) good notches, could result in strap
separation. Before moving any package be certain that the seal is formed as shown.
Inspect the joint to make certain it appears as shown in the illustration. If not, remove the
broken strap and check the tool for worn or broken parts. Repair the tool for worn or
broken parts. Repair the tool before applying another strap.