Signify Classified - Internal
www.lightolier.com
page
1/28/2019
1
Track Lighting
LWWJ Series
LyteSpan BoldFlood
Read and understand these instructions before installing luminaire (fixture).
This luminaire is intended for installation in accordance with the National Electrical Code and local regulations.
To assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electrical shock, turn off electricity at fuse box before proceeding. Allow fixture to cool
before handling.
Retain these instructions for maintenance reference.
INSTRUCTIONS FOR INSTALLING AND OPERATING LWWJ20 AND LWWJ40 SERIES TRACK HEAD.
FOR USE WITH 120V JUNO T, TU AND R SERIES OR CON-TECH LT SERIES TRACK SYSTEMS ONLY
Juno is a registered trademark of Juno Manufacturing Inc.
Con-Tech is a registered tracked mark of Conservation Technology L.L.C.
-
Compatible with ceiling mounted track..
-
Compatible with certain types of dimmers. See specification sheets for compatible dimmers.
-
Compatible with 81LV4 Louver and 81VZ4 Visor.
-
CAUTION: HOT SURFACE. Keep away from curtains and any other combustible materials.
-
CAUTION: Turn power off and allow fixture to cool before handling.
-
CAUTION: No consumer serviceable parts. Contact factory if service is required.
-
CAUTION: For use in dry locations only.
TRACK
HOT
CIRCUIT
NEUTRAL
CIRCUIT
Fig. 1
JUNO TRACK
SINGLE CIRCUIT
GROOVE
TRACK
GROOVE
ADAPTER
LOCKING
TAB
Fig. 3
INSTRUCTIONS FOR ATTACHING LUMINAIRE TO TRACK.
1.
Turn off power to TRACK.
A. JUNO TRACK
FIG. 1
1. Insert luminaire into TRACK. LOCKING TAB on ADAPTER on GROOVE side of track. FIG. 3
2. Rotate ADAPTER clockwise 90° until LOCKING TAB snaps into track. FIG. 3
3. TO REMOVE: Pull down on LOCKING TAB and rotate ADAPTER counterclockwise.
B. JUNO 2 CIRCUIT TRACK
FIG. 2
TO POWER ON LOWER CIRCUIT:
1. Ensure CONTACTS are at the same level. Push down contacts if needed.
2. Follow instructions on page 1 for installing into track.
TO POWER ON UPPER CIRCUIT:
1. Raise MOVEABLE CONTACT (on the left side of the LOCKING TAB)
by using a FLAT HEAD SCREW DRIVER as high as stop permits. FIG. 4
2. Follow instructions on page 1 for installing into track.
FIG. 2
JUNO TRACK
TWO CIRCUIT
TRACK
NEUTRAL
CIRCUIT
UPPER
CIRCUIT
GROOVE
LOWER
CIRCUIT
FIG. 4
ADAPTER
MOVEABLE
CONTACT
LOCKING TAB
FLAT HEAD
SCREW DRIVER
