ATTENTION: Install in accordance with national and local building and electrical codes
.
!
Page 1
Mount Spacing
TruGroove fixture modules are designed for exact on-grid mounting.
For non-
accessible ceilings, mounts are adjustable within 5” of each
module end.
Mounts are adjustable to within 5” of module end(s).
TruGroove Endcap Kit(s)
•
TG D/I endcap (x1)
•
Sling cable assembly (x1)
•
#8 sheet metal screws (x2)
•
#8-
32 x 5/16” hex screw (x2)
•
Cable Strain Relief (x1) (Heyco
#7418)
•
1/2” Bushing (x1)
•
1/2” Plug (x1)
System Overview
These instructions review how to install TruGroove suspended fixtures. TruGroove 4ft, 6ft and 8ft modules
can be installed as individual standalone units, or they can be joined together to create continuous runs. The
graphics below show the components required to install a typical run of TruGroove suspended fixtures.
IMPORTANT: Read all instructions before beginning installation.
Module Lengths
TruGroove suspended fixtures come in 4ft, 6ft and 8ft modules.
Overall module lengths are shown below.
Add 0.2” for each
endcap for accurate run length.
48”
72”
96”
4FT Module
6FT Module
8FT Module
Up To
5”
Adjustment
Up To
5”
Adjustment
Tools Required:
•
1/4” Nut Driver
•
3/8” Nut Driver
TruGroove Joint Kit(s)
•
Sling cable assembly (x1)
•
Joiner aligner (x2)
•
Joiner biscuits (x2)
•
#8 sheet metal screws (x2)
•
#10-
32 x 3/4” (x2)
•
#10-32 hex lock nut (x2)
•
Cable Strain Relief (x1)(Heyco
#7418)
•
1/2” Bushing (x1)
•
1/2” Plug (x1)
•
Phillips Screwdriver
•
Flat or #2 Robertson Screwdriver