Figure 3:
Slider Switch
(default setting 5 shown)
Wattage Power
Input Symbol
Adjustable
Power "+" Red
Driver Wire
Neutral "-" Blue
Driver Wire
*DO NOT REMOVE*
Connector
Release Tab
(3000K)
DO NOT INSTALL FIXTURE WITHIN 10 FEET (3.05 METERS) OF A POOL, SPA OR FOUNTAIN.
INSTALLATION INSTRUCTIONS
1. Make sure power is turned OFF before installing or servicing this fixture.
2. This fixture must be mounted according to the installation instruction sheet, 32000853. Mounting templates
and instructions on how to use the mounting accessories are provided with those instructions.
3. To access the wiring compartment and finish the installation, the fixture must be partially disassembled.
-Loosen the four screws on the faceplate, as shown in Figure 1, to remove the faceplate.
-Remove the two screws indicated in Figure 2 to remove LED/driver assembly.
4. Connect conduit to housing. NOTE: Only use side conduit entries and plug both bottom conduit entries
(and unused side conduit entry, if applicable) as shown in Figure 1.
5. Pull wires from conduit into the housing and connect to LED driver module.
-Connect black (line) supply wire to black wire on LED driver using wire nut.
-Connect white (neutral) supply wire to white wire on LED driver using wire nut.
-Connect green (ground) supply wire to copper ground wire inside housing using wire nut.
-If using an external dimming device, connect appropriately to existing [2] wago connectors.
6. Adjust lumen output by sliding the switch to the desired setting. Factory default is setting 5 (9.2W).
There are [5] different settings ranging from 2.7W to 9.2W. See chart on Page 1 for approximate lumen values.
Heatsink has a "+" and "-" symbol to illustrate wattage level. See Figure 3.
If using external dimming, then switch must be in position of setting 5.
7. Adjustment of LED color temperature from 3000k warm (factory preset) to 4000k cool is optional.
To change CCT color, use a small tool (screw driver, ball point pen, etc.) and remove red driver wire from
bottom board connector (WW) by pressing on connector tab as indicated in Figure 3 to release wire.
Then slide red wire into top connector (CW).
8. Reassemble the fixture.
-Install LED/driver assembly in housing and secure in place with two screws previously removed.
-Position faceplate on front of fixture and tighten the four screws to seal fixture.
9. Turn power ON.
WARNING:
DO NOT TOUCH LEDS!! IMPROPER HANDLING MAY CAUSE DAMAGE .
page 2 of 2
32001290, revision K