ORIENTATION & SERVICING PROCEDURE
PROCEDURE FOR 14” SQUARE HOUSING
LENS DOOR: Open lens door by loosening 4 #8-32 screws (captive) and carefully allow door to swing down. Door is held by safety cables and can be
removed if necessary. See Fig 4 & 5.
REFLECTOR: After opening lens door, the reflector may be hinged down or removed if desired. LED and reflector assembly can be rotated in any direc-
tion based on the lighting application. Ensure that reflector hinges on the correct side for your application. See Fig. 8 below for light direction example.
Loosen 4 #8-32 screws (captive) and carefully allow reflector assembly to hinge down 90
º
(Fig. 6). The reflector can be removed by sliding assembly to
the right and lifting up while slightly angling (around 20
º
) to unlock tabs (Fig. 7). Hinge reflector assembly on correct tabs and follow directions in reverse
to complete installation.
Locking Tabs
Door Screws
Reflector
Screws
1
2
Light direction
Hinge Tabs
Reflector Assembly
PN 442295163171 Rev B
2/20/2020
page 2
www.gardcolighting.com
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
