Chapter 6
| Remote Monitoring Commands
– 181 –
threshold, reaches the falling threshold, and again moves back up to the
rising threshold.
◆
If the current value is less than or equal to the falling threshold, and the
last sample value was greater than this threshold, then an alarm will be
generated. After a falling event has been generated, another such event
will not be generated until the sampled value has risen above the falling
threshold, reaches the rising threshold, and again moves back down to the
failing threshold.
Example
Console(config)#rmon alarm 1 1.3.6.1.2.1.16.1.1.1.6.1 15 delta
rising-threshold 100 1 falling-threshold 30 1 owner mike
Console(config)#
rmon event
This command creates a response event for an alarm. Use the
no
form to
remove an event.
Syntax
rmon event
index
[
log
] | [
trap
community
] | [
description
string
] |
[
owner
name
]
no rmon event
index
index
– Index to this entry. (Range: 1-65535)
log
– Generates an RMON log entry when the event is triggered.
Log messages are processed based on the current configuration
settings for event logging (see
).
trap
– Sends a trap message to all configured trap managers (see
the
command).
community
– A password-like community string sent with the trap
operation to SNMP v1 and v2c hosts. Although this string can be set
using the
rmon event
command by itself, it is recommended that
the string be defined using the
prior to using the rmon event command. (Range: 1-32 characters)
string
– A comment that describes this event.
(Range: 1-127 characters)
name
– Name of the person who created this entry.
(Range: 1-32 characters)
Default Setting
None
Command Mode
Global Configuration
