6
SIGNAMAX LLC • www.signamax.eu
The Switch was designed for easy installation and high performance in an environment where
traffic on the network and the number of users increase continuously.
1.4.1 Hardware Interface
z
24-Port 10/ 2-Port 10/100/1000Mbps
z
24×10/100Mbps
Auto-negotiation Fast Ethernet RJ45 ports
z
2 ×1000Mbps Auto-negotiation Ethernet RJ45 ports
z
All RJ45 ports support auto MDI/MDIX, so there is no need to use cross-over cables or an up-
link port
z
Full-/half- duplex transfer mode for 10/100Mbps Fast Ethernet transmission
z
Wire speed reception and transmission
z
Fully compliant with IEEE 802.3 10BASE-T, IEEE 802.3u 100BASE-TX and IEEE802.3ab
1000BASE-T
1.4.2 Performance Features
z
8.8 G bps switching fabric capacity
z
Support 8K MAC address.
z
512KBytes
packet
buffer
z
Wire speed packet forwarding rate per system.
z
Store and forward switching scheme.
1.5 Panel
1.5.1 Front Panel Components
The front panel of the Switch consists of LED indicators, 24-Port 10/ 2-Port
10/100/1000Mbps Gigabit. The figure below shows the front panels of the Switch.
Figure 1-2
Front Panel view of the Switch
z
10/100BASE-TX Twisted-Pair Ports (Port1~24): These ports support network speeds of either
10Mbps or 100Mbps, and can operate in half- and full- duplex transfer modes. These ports
also support automatic MDI/MDI-X crossover detection, giving true “plug and play” capability.
Just need to plug-in the network cable to the hub directly and don’t care if the end node is NIC
(Network Interface Card) or switch and hub.
z
10/100/1000M
Gigabit
Ports (Port 25,26)
z
LED Indicator: Comprehensive LED indicators display the status of the switch and the network
(see the LED Indicators chapter below).
