SCP 111
S-DIAS SAFETY CPU MODULE
Page 34
04.11.2020
7.3
Troubleshooting
•
Check all modules in the system for completeness and Type conformity
•
Check that all modules are error-free
•
Check all connector cables
•
Cancel the error with the QUIT_ERROR command
If the Safety CPU remains in the error status after the QUIT_ERROR command has been
executed, it must be retested using the SafetyDesigner.
7.4
Troubleshooting with the SafetyDesigner
Connect the SafetyDesigner
Debug the system using the SafetyDesigner.
7.5
Correcting a Wiring Error
When a wiring error is determined, a controlled deactivation of the system is
required, which must then be turned off.
Wiring and mounting can only be performed when no power is applied.
Lors de la détection d'une erreur de câblage, le système doit être arrêté en mode
contrôlé et mis hors tension.
Le câblage et l'installation ne peuvent être effectués que sur un système hors
tension.