BUILD-IN TOUCH TERMINAL
ETT 2144
12.02.2020
Page 23
9
Assembly/Installation
9.1
Check Contents of Delivery
Ensure that the contents of the delivery are complete and intact. See chapter 1.3Contents of
Delivery for more information.
On receipt and before initial use, check the device for damage. If the device
is damaged, contact our customer service and do not install the device in
your system.
Damaged components can disrupt or damage the system.
9.2
Installation
The following instructions must be followed when installing the terminal:
•
For installation with the screw terminals provided, it is recommended that the installation
panel have a material strength of at least 1 mm and a maximum of 2 mm. The screw-in
brackets can be tightened with a maximum torque of 0.2 Nm. For this purpose, a 3x 0.5
flat-tip screwdriver is required.
•
To avoid damage to the aluminum frame, it is important to ensure that during installation,
the contact surface is clean (free of debris, uneven areas). Unevenness can lead to
stress on the glass/aluminum frame or contamination from dust and water.
To dissipate the waste heats from the device, the clearance between the heatsink of the PIM
and the back wall should be at least 45 mm.
The device’s power loss can reach up to 30 Watts. To ensure the necessary air circulation
for cooling, the mounting instructions must be followed!
