ZIRC-SD3502 Z-Wave AV / IR Remote Control
1
1
All information are correct at the time of release. Sigma Designs owns the proprietary rights to the information contained herein this document. It may not be
edited, copied or circulated without prior written agreement by Sigma Designs.
© 2012 Sigma Designs, Inc.
2.8
Send Node Info
Some devices set up automatic associations on receiving a Z-Wave Node Information Frame (NIF) from
the target device. For this purpose, pressing & holding SETUP+INFO for 3 seconds will cause the LED to
blink green once and send out the NIF once. This feature is also a requirement for Z-Wave certification.
2.9
Wake up
To conserve power, the ZiRC remains asleep until a key is pressed after which it goes back to sleep after
3 seconds.
To enable the ZiRC to stay awake for an extended period of time and to notify that it has woken up so as
to carry out any configuration, press & hold SETUP+YELLOW for 5s. The LED should blink green once to
signal it has woken up and notified the STB, at which point the user may release the buttons. The
remote stays awake for 10 seconds only during which time the LED will blink amber every 3 seconds.
2.10
Update Associations
From time to time, the STB may create associations with other STBs to allow simultaneous control from
one remote control. Wake the remote up as described in 2.7. Note that wake up time is extended only
by association commands received from the STB. So quickly set the STB to update the associations. The
LED should blink green thrice on successful association. The process is terminated by any button press
or timeout with the LED blinking red thrice.
If no associations are set up, the ZiRC will control the controller that added it to the network. Otherwise
it will target all the nodes in the group.
2.11
Test mode
This is not a normal user function but rather an advanced function used for testing. When the remote is
in test mode the green led will keep flashing every second. The remote exits test mode after 60
seconds.
2.11.1
Carrier frequency
Press FILE+PGUP+ZOOM+PAUSE and hold for 10s.
2.11.2
Response to HomeID 0
Press FILE+PGUP+REV+MENU and hold for 10s.
