Sigma ROX 10.0 GPS, Operating Instructions Manual, Page: 11 / 60

page 11
synchronizing the sensors
Attaching the RoX 10.0 gps and initial use
www.sigmasport.com ROX 10.0
ROX 10.0
2.5 Synchronizing the sensors
To synchronize the sensors, the RoX 10.0 gps must be switched on and in
training mode.
once synchronization is complete, the respective values appear on the
RoX 10.0 gps’s top display segment in ‘bikecomputer’ view mode.
Note:
The RoX 10.0 gps has been designed for use with up to three bikes. you have
already used the pairing menu to assign the sensors to a specific bike (bike 1, 2,
or 3). you must manually select the bike that you are riding (default: bike 1).
This can be done as follows:
− open the short menu (simultaneously press the two top buttons –
BACK
and
ENTER
)
− press or to go to ‘bike selection’
− press
ENTER
− press or to select the relevant bike
− press
ENTER
to confirm
− press
BACK
to exit the short menu
IMPORTANT:
The RoX 10.0 gps only displays values for paired sensors for which you have
chosen a bike.
2.5.1 Synchronizing the speed
There are two options for synchronizing the speed:
− start cycling – the receiver usually synchronizes with the sensor after five
wheel rotations.
− Turn the pedals until the current speed appears on the display.
2.5.2 Synchronizing the cadence
There are two options for synchronizing the cadence:
− start cycling – the receiver usually synchronizes with the transmitter after
five pedal rotations.
− Turn the pedals until the current cadence appears on the display.